What Size Actuator Do I Have?

/in ,

Refer to this blog post for details about the actuator. Or simply use the measurements below to compare its size when shaft is fully extended.

kenco actuator side by side size comparison with tape measure

 

Actuator Size – Which One Do I Have?

/in

kenco actuator dimensions and size

Can I replace the rubber lining on my Kenco Pipe Lift?

/in ,

Yes, you can replace this. It is adhered with a 3M adhesive and we can provide that for you as well, just ask.

Pricing for the rubber kits are as follows.

PL1500 Rubber Liner – $39.50

PL2000 Rubber Liner – $44.50

PL2150 Rubber Liner – $47.00

PL2250 Rubber Liner – $50.00

PL2500 Rubber Liner – $55.50

PL2750 Rubber Liner – $78.50

PL3000 Rubber Liner – $86.00

PL3500 Rubber Liner – $133.75

PL4500 Rubber Liner – $169.50

What is the DAILY proper maintenance of my Kenco Barrier Lift?

/in , ,

In order to catch any issue quickly, we recommend doing a quick check on your lifter at the start of each work day it will be used. Perform the following:

  1. Visually inspect Kenco Barrier Lift for signs of stress and wear.
  2. Check that bolts and nuts are snug.
  3. Ensure free movement of all components.
  4. Ensure that all warning labels are present and readable. (New sticker kits are available for purchase – sales@kenco.com)
  5. Check that the actuator mounting screws are snug and seated. *top two bolts found on the mounting plate above the actuator
  6. Lubricate all moving mechanisms with penetrating oil. DO NOT USE GREASE.
  7. Lubricate actuator with penetrating oil (ex. WD-40). NEVER use anything other than a light penetrating oil on the actuator. Grease will cause the actuator to gum up and will cause it to not operate properly. Grease also attracts ducts and particles which causes the actuator to not move smoothly.

Pads (also at start of the work day)

  1. Check that all pad mounting bolts and nuts are tight.
  2. Verify freedom of rotations for the pad angles.
  3. Ensure that the pad material is sound, and not de-laminated from backing plates.
  4. Ensure that pad mounting bolt heads are a minimum of 3/32″ below the surface of the pad. *see below
  5. Ensure pad surfaces are clean and free of any foreign substance or material.

How do I tell if I need new pads for my lifter?

/in , , , ,

Replace pads if:

  1. Surface of any given mounting bolt is not at least 3/32″ below the surface of the pad.
  2. There is any de-lamination of the pad from the backing plate.
  3. There is any scarring, chunking, or missing pad material constituting a total combined loss of surface area greater than 3 square inches per pad.
  4. There is any single scar, chunk, or missing pad material that is greater than 1 square inch per pad.

Replacement pads can be found https://kenco.com/store/#pads

Why is my lifter slipping?

/in , , ,

The following are a few items to check:

  1. Is the object you are trying to lift within the lifter’s range? If not, contact our sales team to discuss.
  2. Check pad wear. If the pads’ surfaces are in poor condition, slipping may occur. Refer to your manual or this FAQ section for details on checking pad wear.
  3. Is there debris between pads and object? This can be oils, dirt, paint or likewise.
  4. Is the lifter positioned over the center of gravity of the object? Having a large offset creates an unsafe lifting situation and can cause damage to the lifter.